Extension Length In Thermowell. a thermowell is specified with a lagging extension if the thermowell will be installed in a vessel or piping system that is covered in insulation. El (sometimes l) = installation length (of the thermowell) is how far the well will extend into the process once threaded into the process. to achieve the highest possible accuracy and efficiency, the insertion length of the thermowell must be long enough to allow the entire length of the sensitive. The extension length (see figure 7) typically adds 3” or 6” to the sensor. the standard lagging extension is 3˝ (except for thermowells with a 2½˝ “u” the t will be 2˝). Non standard extensions can be supplied. extension length (e length): lagging extension length (t) the lagging extension commonly referred to as the “t” length is located on the cold side of the process connection and is usually an. This feature is not always used.
from automationforum.co
Non standard extensions can be supplied. This feature is not always used. the standard lagging extension is 3˝ (except for thermowells with a 2½˝ “u” the t will be 2˝). extension length (e length): a thermowell is specified with a lagging extension if the thermowell will be installed in a vessel or piping system that is covered in insulation. to achieve the highest possible accuracy and efficiency, the insertion length of the thermowell must be long enough to allow the entire length of the sensitive. The extension length (see figure 7) typically adds 3” or 6” to the sensor. lagging extension length (t) the lagging extension commonly referred to as the “t” length is located on the cold side of the process connection and is usually an. El (sometimes l) = installation length (of the thermowell) is how far the well will extend into the process once threaded into the process.
Thermowell Insertion and Immersion Length
Extension Length In Thermowell the standard lagging extension is 3˝ (except for thermowells with a 2½˝ “u” the t will be 2˝). This feature is not always used. to achieve the highest possible accuracy and efficiency, the insertion length of the thermowell must be long enough to allow the entire length of the sensitive. El (sometimes l) = installation length (of the thermowell) is how far the well will extend into the process once threaded into the process. the standard lagging extension is 3˝ (except for thermowells with a 2½˝ “u” the t will be 2˝). Non standard extensions can be supplied. a thermowell is specified with a lagging extension if the thermowell will be installed in a vessel or piping system that is covered in insulation. The extension length (see figure 7) typically adds 3” or 6” to the sensor. extension length (e length): lagging extension length (t) the lagging extension commonly referred to as the “t” length is located on the cold side of the process connection and is usually an.
